Return to BFS flow
I’ve been working to improve my CFD skills, and have set up a workstation running OpenFOAM – what better case to practice on than one I’ve already done before?
I wasn’t entirely happy with my results from the last attempt, thinking most of the error was due to an improper mesh, so I ran the same case using a better mesh, and an assortment of turbulence models in 2d and 3d.
The reattachment length was found by evaluating the wall shear stress along the bottom wall of the downstream section – where this is zero is the reattachment point. I found the standard model did not reach mesh convergence at any reasonable point, but both and realisable did, giving ~ 4.8 and 5.6 respectively. Both of these are still below the real steady-state value of 7.0, but are much more promising than last time!
I used for the 3d case as well – it was developed specifically for internal flows and is supposedly the best RANS model for BFS flow, but it looks like I need to work on my calibration as I got an of 4.5! This may also be because I imposed a symmetry condition on the centre of the duct – the flow has been reported as two-dimensional along this plane but there are transient 3d effects to take into account.